Multitech CDMA Guía de usuario descargar pdf (Pagina 24)

INTRODUCTION

AT Commands for EV-DO-EV3 Modems

Commands &Y and &P are both used to set the profile to be loaded at startup. &Y instructs the device to load only

the base section at startup. &P instructs the device to load, at startup, the full profile: base + extended sections.

For commands in the base section, the &F command resets values to factory profile defaults.

&F1 resets to factory profile values the full set of base + extended section commands.

The values set by other commands are stored in non-volatile memory outside the profile. Some values are always

stored, without issuing &W. Other values are stored by issuing specific commands (+CSAS, #SLEDSAV, #ESAV). All

of these values are read at power-up.

The values set by the following commands are stored in the profile base section.

COMMAND ECHO E

RESULT MESSAGES Q

VERBOSE MESSAGES V

EXTENDED MESSAGES X

DSR (C107) OPTIONS &S

DTR (C108) OPTIONS &D

DCD (C109) OPTIONS &C

RI (C125) OPTIONS \R

POWER SAVING +CFUN

DEFAULT PROFILE &Y0

S REGISTERS S0;S1;S2;S3;S4;S5;S7;S12;S25;

CHARACTER FORMAT +ICF

The values set by following commands are stored in the profile extended section.

+FCLASS +ILRR +DR

+CSCS +CRC +CVHU

+CREG +CLIP +CCWA

+CPBS +CMEE +CMGF

+CSDH +CNMI #ACAL

#PSMRI #ACALEXT #ECAM

#SMOV #SKIPESC #E2ESC

#CFLO +CALM +CRSL

+CMUT +VTD #PCMTXG

#PCMRXG #DVICFG #CAP

#SRS #SRP #STM

#SPKMUT #E2SLRI #DAC

#PSEL #SHSAGC #SHSEC

#SHSNR #SHSSD #TSVOL

#E2SMSRI #TEMPMON

Note: #TEMPMON is partially stored in non-volatile memory. See command description for details.

The values set by following commands are automatically stored in non-volatile memory, without issuing any

storing command and independently from the profile (unique values), and are automatically restored at startup.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 248 249

Sin comentarios

Multitech CDMA Guía de usuario Pagina 24