Multitech CF220 Guía de usuario descargar pdf (Pagina 24)

Chapter 3: CallFinder Server Installation

Multi-Tech Systems, Inc. CF220-DID CallFinder User Guide 24

4. Connect CallFinder to Ethernet Network

Plug one end of your RJ45 Ethernet cable into the CallFinder’s Ethernet jack (labeled “10/100”) and the

other end into your network Ethernet hub. This Ethernet cable is not included with your CallFinder unit.

Note: Before connecting to the Ethernet Network, make sure that the network to which you are

connecting the CallFinder is not a 192.168.2.x subnet.

If it is a 192.168.2.x subnet, it may clash with the CallFinder because the CallFinder’s default IP

address is 192.168.2.1. To correct this, connect an RJ45 cable directly from the Admin PC to the

CallFinder until the CallFinder’s IP address has been configured. Then connect the CallFinder into

the network.

Figure 3-4: Ethernet connection

5. Connect CallFinder to DID Lines

Plug one end of the phone cable into the CallFinder’s Channel 1 DID jack and the other end into an

analog DID trunk line jack. The DID Line cable is included with your CallFinder.

Caution: Never plug the DID connector into a standard POTS Line. This may damage the CallFinder or

the central office equipment. Use only an analog DID Line.

Repeat for the CallFinder’s Channel 2 DID port.

6. Identify CallFinder’s Extension Ports (FXS/FXO) for Later Hookup

Caution: You must wait until after the CallFinder software has been configured before connecting the

cables between the CallFinder’s Extension (FXS/FXO) Ports and the PBX. Because the

CallFinder and the PBX can both supply battery power, the cable connections must be done

properly. Otherwise equipment damage could occur.

Before making connections to the CallFinder Extension (FXS/FXO) channels, you must know the type of

PBX port to which each CallFinder port will be connected and set the “Extension Port” field in the

CallFinder Channel Configuration screen appropriately.

• When connecting to a PBX Station Port, set the CallFinder channel to FXO.

• When connecting to a PBX Trunk Port, set the CallFinder channel to FXS.

• When connecting to a FaxFinder fax server, set the CallFinder channel to FXS-Pass-Through.

When the Channel Configuration | Extension Port software field has been set properly for both

CallFinder channels, you can proceed to connect the cable between each of the CallFinder’s FXS/FXO

ports and the corresponding PBX port.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 75 76

Sin comentarios

Multitech CF220 Guía de usuario Pagina 24