Multitech MTPSR1-202ST Guía de usuario descargar pdf (Pagina 13)

Chapter 2 - Installation

MTPSR1-202ST

Installation

The installation procedure in Table 2-1 provides the cable connections for the ISDN telephone

network, two types of connections for your Ethernet, a short adapter cable to connect to your PC for

software loading, and finally your power connection. If additional RAM needs to be added, perform

the procedures in Table 2-2. Figure 2-2 shows the ProxyServer’s external connections.

Table 2-1. Installation Procedure

Step Procedure

1 If additional RAM needs to be added, perform the procedures in Table 2-2.

EthernetEthernet

ConnectionConnection

TTelcoelco

ConnectionConnection

PCPC

ConnectionConnection

PowerPower

ConnectionConnection

10BASE T

OFF

POWER

COMMAND PORT

ISDN

PHONE

Figure 2-2. Back Panel Connections

2 Connect the external power supply to the ProxyServer and a live AC outlet. The POWER con-

nector on the back panel of the ProxyServer is a 6-pin circular DIN connector.

3 Connect a PC running Windows® to the COMMAND connector on the back panel of the Proxy-

Server. Use the short RJ45 to DB25 cable provided with your ProxyServer to connect directly to

your PC, or to the serial cable from your PC.

4 Configure the ProxyServer for your application using the procedures in Chapter 3.

5 Connect a network cable to the Ethernet 10BASE-T (RJ45) connector on the back panel of the

ProxyServer. Connect the other end of the cable to the network.

6 Connect one end of an RJ45 cable to the ISDN connector on the back of the unit and connect the

other end to the ISDN Telephone Network (Telco wall jack).

7 Turn on power to the Proxy Server by setting the ON/OFF switch on the back panel to the ON

position.

The Fail LED stays on for a few minutes and should go off.

At this time the Proxy Server is completely cabled. Proceed to Chapter 3 to load your software.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 103 104

Sin comentarios

Multitech MTPSR1-202ST Guía de usuario Pagina 13