Multitech MTPSR1-202ST Guía de usuario descargar pdf (Pagina 9)

Chapter 1 - Introduction and Description

MTPSR1-202ST

Back Panel

The cable connections for the ProxyServer are made at the back panel. Three groups of cables are

used on the ProxyServer -- the Command Port, ISDN, and Ethernet. The cable connectors are

shown in Figure 1-3 and defined in the following groups.

10BASE T

OFF

POWER

COMMAND PORT

ISDN

PHONE

Figure 1-3. Back Panel

ISDN Connector

The ISDN connector (an RJ11 jack) is used to connect the ProxyServer to the WAN.

PHONE Connector

The PHONE connector (also an RJ11 jack) can be used to connect an analog telephone, fax ma-

chine, or modem to your ProxyServer.

Ethernet 10Base-T Connector

The Ethernet 10Base-T connector (an RJ45 jack) is used to connect the ProxyServer to a LAN using

unshielded twisted cable.

COMMAND Port Connector

The COMMAND port connector is used to configure the ProxyServer using a PC with a serial port

and running Windows® software. The Command connector is an RJ45 jack and a short adapter

cable is provided to convert to a standard serial port DB25 female connector.

POWER Connector

The POWER connector (a 6-pin circular DIN connector) is used to connect the external power supply

to the ProxyServer. A separate power cord is used to connect the power supply to a live AC

grounded outlet.

ON/OFF Switch

The power switch applies DC power to the ProxyServer.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 103 104

Sin comentarios

Multitech MTPSR1-202ST Guía de usuario Pagina 9