Multitech MTPSR1-202ST Guía de usuario descargar pdf (Pagina 66)

ProxyServer User Guide

MTPSR1-202ST

Command Implementation

Command: AT

Function: Attention Code

Values: n/a

Default: n/a

Description: This attention code precedes all command strings except the A/ command and es-

cape codes.

Command: RETURN

Function: Command Execution

Default: n/a

Values: n/a

Description: Press the RETURN (ENTER) key to execute a command. The RETURN key is fre-

quently abbreviated <CR> in command examples.

Command: +++AT<CR>

Function: In-Band Escape Code

Values: ASCII

Default: + (43)

Description: The +++AT command causes the ProxyServer to enter command mode, without

disconnecting the call, when it is online with a remote device. The default escape code is three +

characters, followed by the letters AT, up to 80 command characters, and a RETURN (press EN-

TER). The ProxyServer escapes to command mode, executes any commands in the string, and then

remains in command mode. Use the S2= command to change the escape character.

Command: <BREAK>AT<CR>

Function: Out-of-Band Escape Code

Values: n/a

Default: n/a

Description: This command places the ProxyServer in command mode while remaining online.

Enter a break signal, the letters AT, up to 80 command characters, and a RETURN (press ENTER).

Switch Configuration Commands

Use the following

commands to select your network switch type (e.g., EuroISDN Net3) and to specify

other information required to make an ISDN connection.

Command: %A97=n

Function: Dialing Method

Values: n = 0 or 1

Default: %A97=0 (En bloc)

Description: Standardized ISDN signalling protocols, such as DSS1, DSS2, and SS7, support a

“sending complete indication”; i.e., a signal that no more digits will follow. However, appending such a

signal to a telephone number is often impractical; therefore, many private networks send the number

of a called party by using a procedure called overlap sending, in which no sending complete indica-

tion is sent. Computer users, however, can automatically append the sending complete indication to

the telephone number by choosing the en bloc method of sending, which results in faster call setup.

Use the %A97= command to select between the two methods.

%A97=0 En bloc sending during call SETUP

%A97=1 Overlap sending during call SETUP

Command: !C0=n

Function: Network Switch Type

Values: n = 0, 1, 2, 3, 4, 5, or 6

Default: !C0=2 (Net3)

1 2 ... 61 62 63 64 65 66 67 68 69 70 71 ... 103 104

Comentarios a estos manuales

Sin comentarios

Multitech MTPSR1-202ST Guía de usuario Pagina 66

Comentarios a estos manuales

Relacionado con productos y manuales para Redes Multitech MTPSR1-202ST