Multitech MTS2BTA-R Manual de usuario descargar pdf (Pagina 36)

Chapter 2 – AT Commands

Multi-Tech Systems, Inc. SocketWireless Bluetooth AT Commands (S000360H) 36

Connect As Slave Command

Note: If either the slave or the master of the connection issues a disconnect, the module will output

“DISCONNECT.” If a connection is lost unexpectedly, then “LINKLOSS” will be output.

DS Dial as Slave

This command places the Radio in Slave mode where it waits for a connection to occur from a Master.

Format: ATDS

Return Parameter: OK

EXAMPLE SLAVE:

TYPE: ATDS<cr>

REPLY: <cr_lf>OK<cr_lf>

Disconnect Commands

DH Dial Hang Up

This command will disconnect the current connection on channel 0.

Format: ATDH

EXAMPLE:

TYPE: ATDH<cr>

REPLY: <cr_lf>OK<cr_lf>

<cr_lf>DISCONNECT<cr_lf>

<cr_lf>ERROR<cr_lf>

Notes:

• If you send this command over the RF link to a remote Multi-Tech Slave, the Slave will

disconnect and go into Idle mode not Slave mode by design.

• If a connection should unexpectedly be lost, the response will be

<cr_lf>LINKLOSS<cr_lf> instead of <cr_lf>DISCONNECT<cr_lf>.

DHC Dial Hang Up by Channel

This command will issue disconnect to the specified channel.

Format: ATDHC,<Channel Number>

EXAMPLE:

TYPE: ATDHC,00<cr>

REPLY: <cr_lf>OK<cr_lf>

<cr_lf>DISCONNECT,00<cr_lf>

<cr_lf>ERROR<cr_lf>

Notes:

• If you send this command over the RF link to a remote Multi-Tech Slave, the Slave will

disconnect and go into Idle mode not Slave mode by design.

• If a connection should unexpectedly be lost, the response will be

<cr_lf>LINKLOSS,00<cr_lf> instead of <cr_lf>DISCONNECT,00<cr_lf>.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 87 88

Sin comentarios

Multitech MTS2BTA-R Manual de usuario Pagina 36