Multitech MTS2BTA-R Manual de usuario Pagina 42
- Pagina / 88
- Tabla de contenidos
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
Chapter 2 – AT Commands
Multi-Tech Systems, Inc. SocketWireless Bluetooth AT Commands (S000360H) 42
PARK Enable Park
This command manually enables park mode for the device connected in time slots.
Format: ATPARK,<MAX Interval>,<MIN Interval>
Parameters:
• Max Interval: Integer Value
Time [ms] = Max Interval * 0.625ms
• Min Interval: Integer Value
Time [ms] = Min Interval * 0.625ms
EXAMPLE:
TYPE: ATPARK,1000,11<cr>
REPLY: <cr_lf>OK<cr_lf>
OR
<cr_lf>NO CARRIER<cr_lf>
Notes:
• Allow 7 seconds for the slave to drop its average current draw from 45mA to 3mA and go
into PARK. Any UART traffic will cause the Slave radio go back to full operation within
5msec of the first character for 7 seconds before going back into PARK mode without
subsequent data. The Slave will remain connected to the Master because the
BlueRadios Module only supports one connection.
• Both units are required to support park. Park request is sent from both Master and Slave
to go into affect only during an active Bluetooth connection. The order does not matter.
XPARK Exit Park
This command tells the device to exit the park mode.
Format: ATXPARK
EXAMPLE:
TYPE: ATXPARK<cr>
REPLY: <cr_lf>OK<cr_lf>
OR
<cr_lf>NO CARRIER<cr_lf>
Note: Unit will immediately exit park.
RSSI and Link Quality Commands
Golden Receive Power Range
The lower threshold level of the Golden Receive Power Range corresponds to a receive power between -56
dBm and 6 dB above the actual sensitivity of the receiver. The upper threshold level is 20 dB above the lower
threshold level to an accuracy of +/-6 dB.
RSSI Get RSSI Value
This command is used to obtain the RSSI value for an open connection on channel 0. This is a
parameter associated with the ACL connection to a peer device.
Format: ATRSSI
Return Parameters: <RSSI Value>
RSSI Value is in hex, typically from -10 to +31 in integer dB value.
EXAMPLE:
TYPE: ATRSSI<cr>
REPLY: <cr_lf>OK<cr_lf>
<cr_lf>+00<cr_lf>
OR
<cr_lf>ERROR<cr_lf>
- AT Commands 1
- Reference Guide 1
- Table of Contents 3
- Chapter 1 – Introduction 5
- Changing Configuration 6
- Using Multi-Point Mode 8
- Multipoint Examples 9
- Multi-Point Test Scenarios 10
- Repeater Mode 12
- Chapter 2 - AT Commands 13
- URST Reset 14
- FRST Factory Reset 14
- SI Status Information 15
- Security Commands 19
- Set and Read Device Name 20
- RSN Read Service Name 21
- SP Set PIN 22
- OP Overwrite PIN 23
- Configuration Commands 24
- SW22 Write PIO Direction 26
- SW23 Write PIO Level 27
- SW26 Lock User Settings 29
- SW27 Write LED Rate 29
- SW29 Write PIN Lock Mode 30
- SW30 Write Deep Sleep Mode 30
- Inquiry Commands 31
- Connect as Master Commands 32
- DC Dial Channel 33
- DL Dial Last 34
- LAST Read Last Address 34
- MACLR Master Address Clear 35
- Connect As Slave Command 36
- Disconnect Commands 36
- About Command/Data Mode 37
- Data Mode Commands 37
- Utilities – Cancel Command 38
- Pairing Commands 39
- Low Power Modes Using Sniff 40
- SNIFF Enable Sniff 40
- SSNIFF Enable Auto Sniff 41
- CSNIFF Clear Sniff 41
- XSNIFF Exit Sniff Mode 41
- PARK Enable Park 42
- XPARK Exit Park 42
- Golden Receive Power Range 42
- RSSI Get RSSI Value 42
- LQ Get Link Quality 43
- Max Power Command 44
- Variable Storage Commands 45
- PIO Logic Commands 46
- Commands 47
- FTP Client 48
- DHFTP Dial Hang Up FTP 49
- FTPB FTP Browse 49
- FTP Push/Pull Commands 51
- FTP Server 52
- DOPP Dial OPP 53
- DHOPP Dial Hang Up OPP 53
- OPP Push/Pull Commands 54
- Chapter 4 – Examples 59
- From Power Up 60
- Headset Point-to-Point 60
- Headset Multipoint 60
- Example Client Applications 61
- Description Requires 69
- Appendix B – Responses 72
- Appendix C -- UUID Table 79
- Consumption 80
- Command Responses Comparison 81
- Abbreviations 85
Relacionado con productos y manuales para No Multitech MTS2BTA-R
No Multitech ISI551PC El manual del propietario
(31 paginas)
(31 paginas)
No Multitech MTS2BTA-R Especificaciones
(12 paginas)
(12 paginas)
No Multitech ISI552PC El manual del propietario
(28 paginas)
(28 paginas)
No Multitech MR4800E Manual de usuario
(4 paginas)
(4 paginas)
© 2020, manymanuals.es. Todos los derechos reservados | 0.174 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales