
Chapter 2 – AT Commands
Multi-Tech Systems, Inc. SocketWireless Bluetooth AT Commands (S000360H) 57
OPP Server Send Data Example Using TransSend
Enable OPP Server mode and set the COD of the device to a known COD, such as that of a laptop so that
TransSend will discover the radio.
Sent: ATSW25,7,1,0,0<cr>
Reply: <cr_lf>OK<cr_lf>
Sent: ATSC,0072010c<cr> // TransSend uses COD filtering, so use a known COD.
Reply: <cr_lf>OK<cr_lf>
Sent: ATURST<cr>
Open your browser and find the picture or block of text you would like to send. After you have done this,
highlight all you wish to send. Then right click it and go to “TransSend to device with Bluetooth”. Click note or
picture. Wait for TransSend to search for devices and select the desired device. If sending text, select “Plain
Text,” to send the data click OK.
Reply: <cr_lf> OPP CONNECT,123456789012<cr_lf>
<cr_lf>PUSH START,John Smith.vcf,0015<cr_lf> //Length is in HEX
This is a test note.<cr_lf>
<cr_lf>PUSH COMPLETE<cr_lf>
<cr_lf>OPP DISCONNECT<cr_lf>
Comentarios a estos manuales