Multitech MTCMR-E1 Manual de usuario descargar pdf (Pagina 13)

Part 1 – AT Commands for All Universal IP Devices

Universal IP AT Commands Reference Guide 13

&W – Store Factory Defaults to NVM

Description: For MT100SEM: Stores factory defaults to the NVM.

For NON-MT100SEM: Stores the default settings of &D, &S, &C, E, and V when they are reset to

defaults via AT&F.

For H3 models: Stores the UIP settings of &D, &S, &C, E, and V when they are reset to defaults

via AT&F. Response of COMMAND NOT SUPPORT may appear and can be ignored. UIP values

are set regardless of the COMMAND NOT SUPPORT response.

Syntax: AT&W

Values: None

+ICF – DTE-DCE Character Framing

Description: This command determines the local serial port start-stop (asynchronous) character framing that

the DCE uses

Note: The input for the command always requires the format value. However, the parity value

is optional and will be set as defined in the table.

Syntax: AT+ICF=[<format value>],[<parity value>]

AT+ICF? Read or show the current value.

Values: <format>

0 – Autodetect (not supported)

1 – 8 Data 2 Stop (supported)

<parity> parameter is ignored

2 – 8 Data 1 Parity 1 Stop (supported)

If no <parity> provided, 3 is used by default as <parity> value

3 – 8 Data 1 Stop (supported)

<parity> parameter is ignored

4 – 7 Data 2 Stop (supported)

<parity> parameter is ignored

5 – 7 Data 1 Parity 1 Stop (supported)

If no <parity> provided, 3 is used by default as <parity> value

6 – 7 Data 1 Stop (supported)

<parity> parameter is ignored

0 – Odd (supported)

1 – Even (supported)

2 – Mark (supported)

3 – Space (supported)

4 – None (supported)

Default: Format: 2

Parity: 4

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 118 119

Sin comentarios

Multitech MTCMR-E1 Manual de usuario Pagina 13