Multitech MTCMR-E1 Manual de usuario descargar pdf (Pagina 97)

Part 6 – AT Commands for GPS-Enabled Device

Universal IP AT Commands Reference Guide 97

#GPSURAIS – Set GPS Unique Remote Asset Identification String

Description: This command is used to set a unique remote access identification string for each device or

vehicle.

Syntax: AT#GPSURAIS="<value>"

AT#GPSURAIS? or AT#VGPS or AT#VALL

Values: Up to 20 characters in an alphanumeric string

Note: The ID precedes the GPSPREFIX.

Default: " "

Responses: OK

Otherwise ERROR

#GPSINTERVAL – Set GPS Server Transmission Interval

Description: This command sets the interval of time between messages transmitted to the server.

Syntax: AT#GPSINTERVAL=<value>

AT#GPSINTERVAL? or AT#VGPS or AT#VALL

Values: 0 to 65535 (seconds)

Default: 0 (Disabled)

Responses: OK

Otherwise ERROR

#GPSPW – Set GPS Host Login Password

Description: This command sets the GPS host login password, if required. Some GPS hosts may require a

simple password login mechanism.

Syntax: AT#GPSPW="<value>"

AT#GPSPW? or AT#VGPS or AT#VALL

Values: Alphanumeric ASCII text string up to 64 characters.

Default: No default.

Responses: OK

Otherwise ERROR

#GPSGPGGA – Enable/Disable GPGGA Message

Description: This command enables or disables the reporting of NMEA GPGGA messages.

Syntax: AT#GPSGPGGA =<value>

AT#GPSGPGGA? or AT#VGPS or AT#VALL

Values: 0 - Disable

1 - Enable

Default: 1

Responses: OK

Otherwise ERROR

1 2 ... 92 93 94 95 96 97 98 99 100 101 102 ... 118 119

Sin comentarios

Multitech MTCMR-E1 Manual de usuario Pagina 97