Multitech MTCMR-E1 Manual de usuario Pagina 14

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 119
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 13
Chapter 1 General AT Commands
14 Universal IP AT Commands Reference Guide
Examples:
+ICF input values
Format
Parity
Data bits
Stop bits
Parity
1
0-4, blank (ignored)
8
2
None
2
0-4, blank
8
1
0-4; 3 if the input is left blank
3
0-4, blank (ignored)
8
1
None
4
0-4, blank (ignored)
7
2
None
5
0-4, blank
7
1
0-4; 3 if the input is left blank
6
0-4, blank (ignored)
7
1
None
+IFC Set Flow Control
Description: Turns flow control on and off.
Syntax: AT+IFC=<flow control value>
Values: 0,0 Flow Control Off
2,2 Hardware Flow Control On
Default: 2,2 Hardware Flow Control On
+IPR Set Serial Speed
Description: Sets the serial speed.
Syntax: AT+IPR=<serial speed value>
Values: 300 to 921600
Display: AT+IPR? Displays the current serial speed.
AT+IPR=? Displays a list of all possible values (serial speeds).
Default: For All Products: 115200
#AUTORESET - Reset the Processor at a Given Time
Description: Set an amount of time when the modem will reset after no input has been detected on the
serial port.
This command is not supported on the SocketEthernet IP (MT100SEM-IP).
Syntax: AT#AUTORESET=<time in minutes>
AT#AUTORESET? or AT#VALL
Values: 0-65535 the time in minutes
From 1 to 5 numeric digits (0 to 9).
Default: 0
#DELFLASH Erase Flash Memory Parameter Values
Description: This command erases the contents of the flash memory and loads with defaults values.
Syntax: AT#DELFLASH
Values: No parameter values.
Vista de pagina 13
1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 118 119

Comentarios a estos manuales

Sin comentarios