Multitech MTCMR-E1 Manual de usuario descargar pdf (Pagina 96)

Chapter 16 – GPS Device AT Commands

96 Universal IP AT Commands Reference Guide

#GPSSERV – Set GPS Host Server Address

Description: This command sets the server IP address or name to which the GPS data will be sent.

Syntax: AT#GPSSERV="<value>"

AT#GPSSERV? or AT#VGPS or AT#VALL

Values: 32-bit number in dotted-decimal notation (i.e., xxx.xxx.xxx.xxx) or

Alphanumeric ASCII text string up to 120 characters if DNS is available. No default.

Responses: OK

Otherwise ERROR

#GPSPORT – Set GPS Host Port

Description: This command sets the GPS host port (TCP, UDP).

Syntax: AT#GPSPORT=<port number>

AT#GPSPORT? or AT#VGPS or AT#VALL

Values: 1 to 65535

Default: 1

Responses: OK

Otherwise ERROR

#GPSPROTO – Set GPS Host Protocol

Description: This command sets the server protocol that the GPS will use (TCP, UDP).

Syntax: AT#GPSPROTO=<value>

AT#GPSPROTO? or AT#VGPS or AT#VALL

Values: 0 - UDP

1 - TCP

Default: 0

Responses: OK

Otherwise ERROR

#GPSPREFIX – Set GPS Message Prefix

Description: This command is used to set a unique identification for each device or vehicle.

Syntax: AT#GPSPREFIX="<value>"

AT#GPSPREFIX? or AT#VGPS or AT#VALL

Values: Up to 4 characters in an alphanumeric string

Note: The prefix is appended to the NMEA message before transit

Default: " "

Responses: OK

Otherwise ERROR

1 2 ... 91 92 93 94 95 96 97 98 99 100 101 ... 118 119

Sin comentarios

Multitech MTCMR-E1 Manual de usuario Pagina 96