Multitech MultiConnect Adapter Guía de usuario descargar pdf (Pagina 108)

Chapter 10 – SMTP Client

Command Line Interface and Application Examples for Multi-Tech Systems, Inc. IP Modules (S000368F) 108

Scenario 5 – Sending a Mime Encoded Binary

Attachment Using the Command Prompt

Sending a Mime Encoded Binary Attachment with the email addresses, subject, and message

body are taken from the command prompt.

Issue the following command:

send-mail

-b

-t "<email-id #1>, <email-id #2>"

-c "<email-id #3>, <email-id #4>"

-s "subject data"

-d "Message body"

The SMTP session then enters into interactive mode requesting media-type, media-subtype, filename, filesize, and

the attachment body as shown in this figure.

When the attachment body reaches the filesize, another message is displayed asking whether to continue with one

more attachment as shown in figure. Type n for No. The email with its attachment is sent only to the to-addresses (if

any) and cc-addresses (if any) entered from the command prompt. The subject and message body are also taken

from the command prompt.

Notes

1. The email is not sent to addresses pre-configured using set commands.

2. At least one address, either the to-address or the cc-address, should be given as an alternative to sending

email directly from command prompt.

3. If the subject option is not specified and is not configured using set commands, SMTP enters into

interactive mode requesting the subject to be entered.

4. Type Ctrl+C to quit the email at any given time.

5. If the host wants to quit the email while sending the binary attachment body, type Ctrl+C and wait for 3

seconds without entering any character to quit the email.

1 2 ... 103 104 105 106 107 108 109 110 111 112 113 ... 153 154

Sin comentarios

Multitech MultiConnect Adapter Guía de usuario Pagina 108