Multitech MultiConnect Adapter Guía de usuario descargar pdf (Pagina 141)

Chapter 13 – SNTP Client

Command Line Interface and Application Examples for Multi-Tech Systems, Inc. IP Modules (S000368F) 141

Scenario 1 – Updating Time from the NTP

Server

This scenario describes the updating of time from the NTP server with Daylight Savings Mode disabled.

Description

The IP module time and date are updated with the time specified by the server and with the

time-zone offset added to the time.

SNTP client should send periodic requests to the server for the time update function

depending on the polling time.

Configuration

1. Mandatory configuration.

Command

set sntp-client enable

Result Responses

Use "show date" or "show time" commands to check.

Time and Date should be synchronized with the server.

Scenario 2 – Updating Time from the NTP

Server

This scenario describes the updating of time from the NTP server with Daylight Savings Mode enabled.

Description

The IP module time and date are updated with the time specified by the server and with the

daylight offset added to the time if the time falls between start and end configuration.

SNTP client should send periodic requests to the server for the time update function

depending on the polling time.

Configuration

1. Mandatory configuration.

2. Optional configuration.

Command

set sntp-client enable

Result Responses

Use "show date" or "show time" commands to check.

Time and Date should be synchronized with the server.

Note:

When the server cannot be reach or is not running, the SNTP client tries to reach the server every 10 seconds

for 6 times and waits for the polling time, and then it tries again to reach the server as before.

1 2 ... 136 137 138 139 140 141 142 143 144 145 146 ... 153 154

Sin comentarios

Multitech MultiConnect Adapter Guía de usuario Pagina 141