Multitech MultiConnect Adapter Guía de usuario descargar pdf (Pagina 110)

Chapter 10 – SMTP Client

Command Line Interface and Application Examples for Multi-Tech Systems, Inc. IP Modules (S000368F) 110

Scenario 7 – Sending a Mime Encoded Binary

Attachment Using Pre-Configuration

Sending a Mime Encoded Binary Attachment With:

• The to-address, cc-address, and subject are pre-configured.

• The message body is entered in the Interactive Mode.

Configure the following details apart from the mandatory configuration:

• Set subject data of maximum length 255 characters.

Command: set send-mail subject "subject data"

• Set to-addresses of maximum length 64 characters.

Command: set send-mail to-address 1 email-id#1

set send-mail to-address 2 email-id#2

• Set cc-addresses of maximum length 64 characters.

Command: set send-mail cc-address 1 email-id#3

set send-mail cc-address 2 email-id#4

Issue the following command: # send-mail -b

The SMTP session then enters into interactive mode requesting the message body to be entered as shown in this

figure. After entering the message, type Ctrl+D to end the message.

The SMTP session enters into interactive mode requesting media-type, media-subtype, filename, filesize, and the

attachment body to be entered as shown in the figure above.

When the attachment body reaches the file size, another message is displayed asking whether to continue with one

more attachment. Type n for No. The email with its attachment is sent only to the pre-configured to-addresses (if

any) and cc-addresses (if any). The subject is also taken from the configuration.

Notes

1. The email is sent to addresses pre-configured using set commands.

2. At least one address, either the to-address or the cc-address, should be configured using set commands;

otherwise, the SMTP session will enter into interactive mode prompting for the required details to be

entered.

3. If the subject is not configured using set commands, SMTP will request the subject to be entered.

4. Type Ctrl+C to quit the email at any given time.

5. If the host wants to quit the email while sending the binary attachment body, type Ctrl+C and wait for 3

seconds without entering any character to quit the email.

1 2 ... 105 106 107 108 109 110 111 112 113 114 115 ... 153 154

Sin comentarios

Multitech MultiConnect Adapter Guía de usuario Pagina 110