Multitech MultiConnect Adapter Guía de usuario Pagina 37

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 154
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 36
Chapter 2 – Command Line Interface (CLI)
Command Line Interface and Application Examples for Multi-Tech Systems, Inc. IP Modules (S000368F) 37
PPP Commands – Setup
PPP Setup Commands
Note: All PPP Commands use the ppp0 interface, which corresponds to the modem port s1.
Command Syntax set ppp <interface> authentication <enable/disable>
Description
Enables/disables PPP Authentication.
Default Value
Disabled
Success
OK
Error 1. Too few arguments
Possible argument(s) are:
enable disable
2. Invalid string
Invalid argument.
Valid argument(s) are:
enable disable
3. Multiple matches
auth-type authentication
Command Syntax set ppp <interface> auth-type <pap/chap/pap-chap>
Description
Sets the protocol to authenticate the remote peer: PAP/CHAP/PAP-CHAP
Default Value
PAP
Success
OK
Error 1. Too few arguments
Too few argument(s). Possible argument(s) are:
chap pap pap-chap
2. Invalid authentication type
Invalid argument. Valid argument(s) are:
chap pap pap-chap
3. Multiple matches
auth-type authentication
Command Syntax set ppp <interface> compression <enable/disable>
Description
Enables/disables CCP compression.
Default Value
Disabled
Success
OK
Error 1. Too few arguments
Possible argument(s) are:
enable disable
2. Invalid string
Invalid argument. Valid argument(s) are:
enable disable
Command Syntax set ppp <interface> comp-type <both/bsd/deflate>
Description
Sets the compression type to BSD, DEFLATE or BOTH.
In the case of NON-RAWMODE:
When both is configured as the compression type, the module tries to
negotiate DEFLATE first. In the event of failure, the BSD is negotiated.
In case of RAW-MODE:
Compress-type both is not supported in RAW-MODE, since there are no
negotiations between IP modules.
Default Value
Deflate
Success
OK
Error 1. Too few arguments
Too few argument(s). Possible argument(s) are:
both bsd deflate
2. Invalid string
Invalid argument "string"
Valid argument(s) are:
both bsd deflate
Vista de pagina 36
1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 153 154

Comentarios a estos manuales

Sin comentarios